ZProcess: No Sound

[tstngry]

First off let me just say that your program is great. I have been using it since you first made it and I probably wouldn't be using gbpvr or the MediaMVP without it.

Now for my problem: I just recently upgraded gbpvr to the latest version without un-installing my previous version first. It installed fine and everything seemed to be working correctly except for ZProcess. So I downloaded the latest version of it and re-installed it. It too seemed to be working fine except for I got no sound when i tired to play videos. So i un-installed everything and started over again. Even with this fresh install I still have no sound. Usually I don't even need to change any settings @ all within ZProcess and it transcodes my movies perfectly. Information on the specific options to mess with to fix this problem would be appreciated. Peace

[zehd]

First off let me just say that your program is great. I have been using it since you first made it and I probably wouldn't be using gbpvr or the MediaMVP without it.

Now for my problem: I just recently upgraded gbpvr to the latest version without un-installing my previous version first. It installed fine and everything seemed to be working correctly except for ZProcess. So I downloaded the latest version of it and re-installed it. It too seemed to be working fine except for I got no sound when i tired to play videos. So i un-installed everything and started over again. Even with this fresh install I still have no sound. Usually I don't even need to change any settings @ all within ZProcess and it transcodes my movies perfectly. Information on the specific options to mess with to fix this problem would be appreciated. Peace

I'm swamped and exhausted from work. I'll be getting back to you on the weekend... Thanks for your patience

[tstngry]

Np, take your time. I would just revert back to the older version but I don't have the old ffmpeg and the new one doesn't seem to work with the new ZProcess. Peace

[tstngry]

I figured it out! I changed the Audio & Video Decoder in the config from the Pure Video one i was using back to system default and it works again. It weird that it would do that. I'm not sure if the problem was one or both, but I will figure that out later. This might be good to know if other people have trouble in the future. Good luck helping the other people. Peace

[zehd]

Just so you know, neither ZProcess nor FFmpeg use the codec settings in GB-PVR...

There was something else going on. Glad you were able to get it going....

[zehd]

This thread is now closed. If you have a similar problem, please post a new thread...