Noob needs help - Setting up channels!

[Metallator]

Hello there!

I have tried everything and I have read about everything about the subject, but I cannot get it to work: On Live-TV I only see snow and static.

My config:
- Hauppauge PVR150MCE
- Windows 2003 Server
- Cable-tv (Provider: UPC)

In WinTV2000 I have setup all the channels manually, by entering the Mhz's, and it is working fine.

When I go to the GB-PVR config util on the Tab: Capture Sources, I add:
"Hauppauge analog"
Direct Recording Plugin
- Hauppauge PVR150MCE
- Netherlands
- Capture Device #1
- Internal Tuner; tuning Cable

XMLTV Plugin (works)
Changer: No Channel Changer required
All Channels are enabled

The channels are listed from the XMLTV-xml file and all are enabled.

On the Channels-tab all channels are listed.

But when I start GB-PVR and select Live-TV, all the channels are just snow.

I also ran Freq2Reg, and copied the Hauppauge channels-hive to the Microsoft TV-system hive,
but with no effect.

It seems that GB-PVR doesn't pick the channels I have configured... I have read a tip that I should enter all channels in Mhz in the GB-PVR tool, but I seem to overlook the right spot...!

Can anyone help me with this problem? Thanks a lot in advance!!
(Note: I have added my logfiles )

[sub]

When you run the tuning assistant, do you see your channels?

[Metallator]

OMG, just found out that you can simply fill in the Mhz in 'Source channel' on Capturing Device-tab.

Like this:
Name Ch Freq Enter
Ned 1 58+ 768.00 768000000
Ned 2 59+ 776.00 776000000
Ned 3 60+ 784.00 784000000
RTL 4 56+ 752.00 752000000
RTL 5 55+ 744.00 744000000
SBS 6 54+ 736.00 736000000
etc.

It would be great if it was documented somewhere....

Regards,
Metallator

[sub]

Good to hear you got it working.

It would be great if it was documented somewhere....

It is documented in the wiki.

[Metallator]

Hello Sub,

Sorry to have bothered you..., but I probably overlooked it.