HD Homerum and GB-PVR

[whurlston]

Download and install graphedit:
http://www.videohelp.com/tools/GraphEdit

Run graphedit and go to Graph, Insert Filters.

Expand "BDA Network Providers" and double click on "Microsoft ATSC Network Provider" to add it to the workspace.

Expand "BDA Receiver Component" and check that you can see the two "Silicondust HDHomeRun Tuner XXXXXXXX-X" devices.

Expand "BDA Source Filters" and check that you can see the two "Silicondust HDHomeRun Tuner XXXXXXXX-X" devices. Double click on the first one.

Move the filter window to the side so you can see the workspace. Connect "Antenna Out" to "Input0" by drawing a line with the mouse.

Back in the filter window expand "DirectShow Filters" and double click on "MPEG-2 Demultiplexer".

On the workspace connect "Output1" to "MPEG-2 Stream"
The demultiplexer should now show 5 outputs.

Let me know if this is not the case.

[wa4bwb]

Did the cleaning you recommended. Same problem. The tuners kept multiplying each time I opened Config so I did another clean install. Now the multiplying tuners don't show up each time I reopen Config which, by the way, I'm not fiddling around in there. I'm only trying to get past the channel mapping while using Config. I've double checked the entries in the inf and bda files and they all seem correct. I've even used the wizzard and it says both ini files for the tuners are already added. I think I will rest on it a while.