2007-06-30, 02:59 PM
I've just upgraded to Vista and the latest GB-PVR, and I keep getting a "no channels found" error when I try to do the channel mapping.
I'm using a Hauppage Nova-T stick which was working fine before the upgrade. I was previously using GB-PVR 0.97 (the EXE version is 1.0.2547.35214).
As far as I am aware the settings are all the same. I've edited BDA.INI to include the device and checked its name with Graphedit - this works fine because it's detected as an installed device.
During the scan several channels report Strength of 141-142 and Quality of 100. However when the scan finished it reports "no channels found".
Any ideas? What should be my next step in fault finding?
Thanks
Andrew
I'm using a Hauppage Nova-T stick which was working fine before the upgrade. I was previously using GB-PVR 0.97 (the EXE version is 1.0.2547.35214).
As far as I am aware the settings are all the same. I've edited BDA.INI to include the device and checked its name with Graphedit - this works fine because it's detected as an installed device.
During the scan several channels report Strength of 141-142 and Quality of 100. However when the scan finished it reports "no channels found".
Any ideas? What should be my next step in fault finding?
Thanks
Andrew
