FF and Rewind in recordings

[Dai]

The fast forward works for me in this version, (thanks for that sub) but I still have a little problem with it.

While fast forwarding, if I press play, it does not play from the point it had got to in the fast forward, it seems to jump back about 15-30 seconds and play from there. I have a work arround, if press pause while fast forwarding it pauses at the correct place and if press pause again it plays from the correct place but I was wondering if anyone else has problems with pressing play while fast forwarding.

Also, rewind does not work properly for me. instead of playing the file backwards it seems to play a few frames forward and then jump a little bit play another few frames forward etc. again, I'm wondering if it works OK for others or if it is just not finished yet.

[box177]

I've got same behavior.

[willetin]

I'm new to this wonderfull PVR (15e), but have same problem with recordings, this is an old post, do I miss something?

[bs007]

I have this problem too. I found that in the real world I am fastforwarding a lot (commercials), and that I do not edit the recording because that just takes too much time. Maybe a "skip one minute" button would be a nice addition.

[Dady]

Hi all,
I have the same problem: during a scheduled recording I can play, but I can't ff or rev. During a playback of a finished record I can't ff or rev (only speed controls...) and when I play again the record with play button, it restarts from the begin...!

Does someone have any ideas?

Thanks a lot!
Dady

[nkh]

Quote[/b] (bs007 @ April 18 2004,09:28)]Maybe a "skip one minute" button would be a nice addition.

The two bottom buttons on the Hauppauge remote, labled "Replay" and "skip" does just that. There's a keyboard equvilant somewhere but you'll have to find it in the documentation yourself.

Thoes buttons together with the FF/REW buttons set to skip 10 sec is perfect for commercial skipping...

[Mascot]

Quote[/b] ]The two bottom buttons on the Hauppauge remote, labled "Replay" and "skip" does just that. There's a keyboard equvilant somewhere but you'll have to find it in the documentation yourself.

http://www.gbpvr.com/QuickStart/shortcuts.htm