Angel usb tunners

[Wind]

I have two Angel Usb tuners. I Have two source setups. They are set as capture card one and two. The tray icon says i have two separate tuners and it makes an attempt to use them both. However when i try to record a show and watch a show at the same time it can never make use of the second tuner. If i disconnect one tuner then start Gbpvr it will open live tv and allow me to watch it no matter wich card is unplugged . It is as if it thinks they two cards are one. How do i get it to see that i have two separate tuners and use them independently ?

[stustunz]

post a screen shot of your setup page for each tuner
depends on the drivers but they need to be either device #1 and device #2 or they will both be device#1 which ever you must have it the wrong way around

[Wind]

The tuners are set to device one and two. However in the pull down menu to select the tuner it only ever shows one angel usb tuner. I am not sure if it is supposed to show two or not but i thought it was worth brining up . The driver version is 3.09. I have also tried the only other driver 3.07 . They both have the same results. Even though you may not need them here are the pictures you asked for . I have also included a shot of device manager showing both tuners install with the same name. I do not know if that is an issue either as i have seen many devices install with a numbered affix .

[whurlston]

Run filtercheck.exe (located in the devnz\gbpvr folder) with both tuners connected then post the resulting filtercheck.log

I suspect that it may change the filter names for additional tuners. I could be wrong though.

You could also try recording two programs simultaneously and post your logs.

[Wind]

Here is the filter check log

[sub]

Based on that filtercheck.log you should have two capture sources, one as device#1, the other as device #2.

If that doesnt work for you, then do two recordings at the same time, then zip and attach the GBPVRRecordingService.exe.log and GBPVRRecordingService.exe-native.log files and I'll take a look.

[Wind]

Here are the requested log files .

[whurlston]

Those logs show that the graph failed but now why. Set your log level to "Debug" in the Config (General tab) and post the logs after trying the recordings again.

[Wind]

Third time's a charm.

[sub]

When it attempts to use the second device it fails to start, and unfortunately only returns some generic failure code.

2008-01-03 09:58:14.406 ERROR failed to start Conexant Graph
2008-01-03 09:58:14.406 VERBOSE ERROR_GEN_FAILURE

Are you sure the drivers support two of these devices in the one machine? The drivers of some devices dont.