Recordings are always recording on fixed channel

[jorm]

I just upgraded to 90.10 and I can schedule recordings but they are not recording on the right channels always on the same channel.

Under recording source I have
source internal tuner
tuning cable.
constant channel is grayed out.

Does anyone have any ideas before I rollback to the previous version?

[cwills]

After upgrading, almost all of my settings were reset, and not upgraded as they usually are. It's possible your capture card was reset(like from a 350 to a 250 or something)I would recommend deleting your EPG/capture source, exiting, re-entering and setting up a new one and see if that works. If all else fails, uninstall, re-install and try it again. I'm using the same settings you are-internal tuner w/cable and mine's working.

[jorm]

Thank you.

That was a difficult upgrade typically it goes smoth.

I had to uninstall and reinstall. It is something in the database that was not being updated right. When I put my old db back I got the same problem.

So I reconfigured from scratch and exported the shows info by hand. Need to write a tool for that. Now everything is smooth. I wonder what is wrong with the upgrade?

Other symptoms that I noticed when the problem was there:

Live tv could not change channel.
Where I setup the capture source no channels were listed.

[KingArgyle]

Yeah, I had a similar problem. Just wipped out the gbpvr.mdb, and started with a clean one. Once everything was setup, I could see my channels (I wasn't seeing any channels in the Episode Guide). A pretty big minor annoyance with this install, but worth going through.

[sub]

I suspect for some reason the database was not upgraded. The upgrade should have added a tuning_request column to the SOURCE_CHANNEL_MAPPING table. I dont think ths happened for some reason.