Front Panel Question

[UncleJohnsBand]

Yea...not too attractive....but it could be worse....I posted a support ticket with them to find out what's up with the plain front....

They responded today.....new front panel is on the way. Can't beat that.

[Lindsay]

It will sure look better with the proper front panel! How the hell did someone not notice???

Are there several side panel versions? Both my side panels are all mesh.

[UncleJohnsBand]

It will sure look better with the proper front panel! How the hell did someone not notice???

Are there several side panel versions? Both my side panels are all mesh.

My side panels are mesh as well....i have noticed that the screws that hold the top on are nicer on mine than the ones I have seen in the pictures online....they are about the size off a Canadian dime about 1/4 inch thick with ridges to grip when unscrewing/screwing.....

[mvallevand]

The screws you see in mods are usually longer to allow some airspace. Yours are probably normal like the standard ones shown her http://www.popcornhour.com/onlinestore/

My screws are much thicker and bigger than our dimes, and thicker than our loonies and toonies for that matter.

Martin

[UncleJohnsBand]

The screws you see in mods are usually longer to allow some airspace. Yours are probably normal like the standard ones shown her http://www.popcornhour.com/onlinestore/

My screws are much thicker and bigger than our dimes, and thicker than our loonies and toonies for that matter.

Martin

Yep...that is what they look like alright.....

I haven't thought too much about any mod's at this point.....I did get 1/2 through the adding a fan thread over on the NMT forum....