2008-05-08, 04:00 AM
Hey,
I changed my:
<BDAPsiScanWaitSeconds> to 60 and scan most transponders perfectly.
I do however have a problem scanning a particular transponder off 119 (Echo 7)
It's transponder #40=12399,V,20000,56
I even created a .ini file with just this transponder, and when I scan it gets a signal lock, but no channels are pulled in.
I've attached my config logs for the scans.
Also, I have some transponders that don't pull all the channels. In that case, I manually tried to enter the PID info in the .cache. It successfully shows the new added channel on the list, but I can't tune it in. I 'm pretty sure I entered the information correctly.
In both cases above, I'm able to tune to them using other dvb software.
I'm using the updated psiparser which sub provided here: http://forums.gbpvr.com/showpost.php?p=2...ostcount=6
Thanks for the help,
CFC
I changed my:
<BDAPsiScanWaitSeconds> to 60 and scan most transponders perfectly.
I do however have a problem scanning a particular transponder off 119 (Echo 7)
It's transponder #40=12399,V,20000,56
I even created a .ini file with just this transponder, and when I scan it gets a signal lock, but no channels are pulled in.
I've attached my config logs for the scans.
Also, I have some transponders that don't pull all the channels. In that case, I manually tried to enter the PID info in the .cache. It successfully shows the new added channel on the list, but I can't tune it in. I 'm pretty sure I entered the information correctly.
In both cases above, I'm able to tune to them using other dvb software.
I'm using the updated psiparser which sub provided here: http://forums.gbpvr.com/showpost.php?p=2...ostcount=6
Thanks for the help,
CFC