HELP: HVR-1600 records garbled ATSC broadcasts

[cheft]

Upgraded from an ATI Remote Wonder Elite to a HVR-1600 in seeking to record both analog cable and ATSC broadcasts. I removed the ATi card.

After installing the new HVR-1600 I added two separate capture sources, one for ATSC and one for Cable, both set to device 1. The ATSC channels are mapped to their respective channels. I can view the ATSC signal while scanning for channels and in Live TV. However when I record I get a small file, approx. 16~20Mb that is just garbled crap. It causes ComSkip to crash sometimes when it scans the file after recording. I can record the ATSC signal fine when I use the WinTV software included with the card.

I still record my analog cable as usual.

I use GBPVR 1.0.16 (I run the gbpvr.exe because the video hardware doesn't support VMR9, which isn't an issue because I watch from a separate location.)

[sub]

What mux are you using? If you switch to the TS Mux and its still happening, then this points to the data being supplied by the card as the problem (probably due to signal problems). If changing the mux corrected it, then it was probably the mux filter at fault.

[cheft]

I'm sorry, I do not know where the mux settings are. How do I change it?

[cheft]

Never mind, It was under the BDA Multiplexor pulldown menu. Let me try to record.
* cheft crosses fingers.

[cheft]

the dvr-ms is the only optioon I have that works.

Can someone tell me why I don't see any Hauppauge option? Did the software not install properly? It must work because the WinTv software works and records to mpeg.