2008-09-06, 10:43 PM
HI, I have an MCE beanbag dual blaster I am using with a 2450hdc STB. I have installed the
new mceir.sys driver
installed hip
learned and verified/blasted stb 0-9 buttons
installed hipsend
configure .exe hipblaster with '{channel} parameter in tuner source of gbpvr config
set up alternate input in hip to accept virtual ir signals from hipsend
Everything is working unless I select a channel higher than 9 (i.e. 2 or more digits consecutively)
I think that gbpvr sends a blast for each digit just like when one uses a stb It appears from the STB that periodically the first digit is received but not the remaining. If I send "134" with the MCE remote, the STB receives "1", if I send "46" the STB receives "4". Has anyone experienced this anomaly or have I got something configured incorrectly. GBPVR seems to be sending the sequences too slow or not at all. Any help appreciated
new mceir.sys driver
installed hip
learned and verified/blasted stb 0-9 buttons
installed hipsend
configure .exe hipblaster with '{channel} parameter in tuner source of gbpvr config
set up alternate input in hip to accept virtual ir signals from hipsend
Everything is working unless I select a channel higher than 9 (i.e. 2 or more digits consecutively)
I think that gbpvr sends a blast for each digit just like when one uses a stb It appears from the STB that periodically the first digit is received but not the remaining. If I send "134" with the MCE remote, the STB receives "1", if I send "46" the STB receives "4". Has anyone experienced this anomaly or have I got something configured incorrectly. GBPVR seems to be sending the sequences too slow or not at all. Any help appreciated