Cant find HW in Tuning Assistant

[sub]

The device number should be #1, since its the only one of these Nova-T devices you've got in your machine.

Post the config.exe.log and config.exe-native.log and I'll take a look.

[Basher52]

here they are (the reinstall of the drivers didnt work)

[sub]

The device number is wrong in those logs. You had it set to #3. It needs to be device #1. Post the log again when you've scanned with it set to #1.

[Basher52]

so, that changed again
ah well, changed that back and it still seems not to find any channels.
even though I have a bad reception it can't be this bad that I don't even see one bit of frame in the window or that every channel keeps getting nuked

hmmm

[sub]

Post the log again when you've scanned with it set to #1.

[Basher52]

...

[sub]

Everything looks fine in those logs, but the device never manages to lock onto a signal.

Are you positive you have a good signal, ie can the Hauppauge WinTV software pickup channels?

[Basher52]

btw... I may not be writing this here, but since you're lookin' here :p :p

The buttons for moving up/down capture devices in the 'GB-PVR Configurtion'/'Capture Source' doesn't have any picture at my place(could be my PC...) that's why I didn't see them until just now, so I could move my Digital card up.

[Basher52]

well it finds channels yes, but it's too much grains in it too be digital.
and it find all channels that the analog card can find and this one had a direct connect to the outlet "in the wall" if you get it

[sub]

well it finds channels yes, but it's too much grains in it too be digital.

If its not finding the digital channels in WinTV, then its probably not going to find them in GB-PVR.