HD PVR with 1.3.7?

[drlava]

The attached patch resolves the issue with the arcsoft video decoder not working.

Does this patch conflict with this patch, both replace NativeUtilities.dll

http://forums.gbpvr.com/showpost.php?p=3...stcount=11

[sub]

Does this patch conflict with this patch, both replace NativeUtilities.dll

Just use the lastest of the patches. They're all part of one chain of builds, so newer patches include previous patches in the same file.

[digitalman161]

Is there a way to change the bit rate and/or fps of an HD PVR recording via GBPVR? The only options I have are High Low Med and they don't seem to make a difference.

I noticed when I choose a different capture card I have ability to change the bit rate but not with the Hauppauge.

[sub]

You can change the bitrate in the AnalogHD.ini file.

[cheval]

Sub,

All short update for you.

Rebuilt the machine running GBPVR over the weekend and was painless to say the least. Had my same problem getting the ArcSoft decoders installed but after using the BIG HAMMER approach of registering all the ax files in the Arcsoft directory it was there again.

The update is that I put a second HD-PVR on the machine and it appears to work just fine. Selected it as the second device and I was up and running.

Again, thank you so much for the patch that made this all possible

In regards to the bit rate, could I second the request to have this functionality implemented outside of AnalogHD.ini. Not like there is probably a thousand other request already in your queue.

[zetavu]

You should be able to set your bitrate and other settings in TME and have them carry over to all your recordings.