Priorities

[BTJustice]

I am experiencing a curious problem that may in fact be a bug with GBPVR.

Say I want to record 10 series. I add the 10 and let the library fill up with a few episodes of each show. I begin to notice that series listed near the top of the list get priority over series listed near the bottom of the list when the times overlap.

Are series listed near the top of the list given higher priority over those listed near the bottom of the list?

This doesn't make a lot of sense as newer series are listed on the top as opposed to be listed on the bottom. Do I have to make a list of what I want to record series-wise then add them in reverse order to prioritize certain series over others?

[naador]

this is intended behavior. you can reorder items in the list with ctrl-d and ctrl-f or the equivalent buttons on your remote (ffwd and rwd)

[BTJustice]

I guess it is just me, but it seems like it is reversed to me. Like the first series I add should be on the top then the second series BELOW it and so on.

So I either have to use those keyboard shortcuts to get them in the order I need or add them in reverse? Bummer.

[martint123]

More tuners

[dennit]

I guess it is just me, but it seems like it is reversed to me. Like the first series I add should be on the top then the second series BELOW it and so on.

That's how the TiVo does it (new "season pass" goes to lowest priority). It took me a while to get used to GBPVR's reverse order, too. When I have long-standing prioritized set of recordings I definitely want to record, but want to add a new series to check it out, I have to be careful to move the new one to the bottom of the list. On the TiVo, when there's a new series I definitely want, I have to be careful to move it to the top. On the whole, I still like the TiVo ordering a bit better, but I can see the opposite view. To the credit of GBPVR, however, moving series around is much, much, much faster than my TiVo.

[BTJustice]

this is intended behavior. you can reorder items in the list with ctrl-d and ctrl-f or the equivalent buttons on your remote (ffwd and rwd)

These don't seem to work. When I go to RECURRING and click on a series to move up or down, nothing happens upon using the keyboard shortcuts.