Hauppauge HVR-900H 111xxx Config Problem

[ssfur]

Hi

After lots and lots of searching I'm at a bit of a loss.....

I've got a hauppauge HVR-900H (USB stick version 111xxx) and gbpvr 1.4.7 running under XP SP3.
The hauppauge WinTV 7 app works fine and shows up all digital channels etc.

However when I installed gbpvr 1.4.7 and ran config and went to the capture sources setup it didn't detect the card (USB stick) at all.
I manually selected the HVR-900H entry and tried to do an EPG map but that said it failed to start the BDA driver (not found).

So after reading lots of helpful info on these forums I tried FilterCheck.exe and took a look at what it says. It says the HVR-900H is actually a "Hauppauge Cx23100". There are very few references to such a device anywhere I can find.

So some more hunting and found http://gbpvr.com/pmwiki/pmwiki.php/Hardw...aptureCard which explains how to add a new card. So I create a new bda.ini entry:

[Hauppauge Cx23100]
TUNING_TYPE=DVB-T
FILTER_TUNER=Hauppauge Cx23100 BDA Tuner
FILTER_CAPTURE=Hauppauge Cx23100 TS Capture
PIN_TUNER_IN=Input0
PIN_TUNER_OUT=MPEG2 Transport
PIN_CAPTURE_IN=Input0
PIN_CAPTURE_OUT=MPEG2 Transport

So now in config|capture sources I add this new card and it likes it a bit better - the EPG map doesn't create an error but unfortuantly nor does it actually find any channels.

So that's where I am - I've added a new entry to bda.ini and can now scan for channels but none are found. (WinTV 7 finds all the channels fine)

I attach filtercheck.log & config.exe.log for reference.

Any thoughts much appreciated....

Thanks

[sub]

Can you do a scan and post the config.exe.log and config.exe-native.log files?

[ssfur]

Ok gonna answer my own post in case it helps anyone else out there - use nPVR not gbpvr, picks up the channels and seems to work a treat and no messing with bda.ini......