IR Server Suite Setup

[ottoguy]

Can someone give some pointers on setting up IR Server Suite with NPVR? I installed the software and programmed in IR commands on the translator. Not completely sure what I need in the Programs section of Translator? I imported an old file for GBPVR and was trying to make it work.

I told NPVR to use the IRBlast.exe file but not sure what arugments I need? The GBPVR doc showed "-host localhost -pad 3 -channel {channel}" (without the quotes).

Any help someone could give would be greatly appreciated. In case it matters I'm using Win7 64-Bit with a Microsoft MCE USB blaster and NPVR.

[pBS]

i have a fairly complete preset file you could load...i may have missed a few npvr buttons as i haven't updated it much lately..
btw, only -channels {channel} is necessary if using localhost..padding can be handled by npvr [check box]
i set all my buttons up in 'system wide' keys with post codes to allow focusless operation...how is yours setup? [so nothing in programs really, just systemwide keys]
i also made a blaster helper to allow more customizing with blasting...[like sending enter and exit after to turn off stb osd quickly]
here: http://forums.gbpvr.com//showthread.php?...post394524 and that thread has good info in it..also on wiki..