2010-12-02, 03:45 PM
I've been going round in circles a bit this afternoon setting up another test machine.
If I change the EPG source to "none" in the bulk map area of setup, it changes to DVB/ATSC EPG when I exit.
(I wondered why there was a lot of scanning when I did an update epg!)
However, I found that changing it by double clicking or "details" the change to "none" stuck.
Cheers.
If I change the EPG source to "none" in the bulk map area of setup, it changes to DVB/ATSC EPG when I exit.
(I wondered why there was a lot of scanning when I did an update epg!)
However, I found that changing it by double clicking or "details" the change to "none" stuck.
Cheers.
