How to disable recording more than 1 programme from a single source mux/frequency?

[ermac]

How to disable recording more than 1 programme from a single source mux/frequency?

Example
in the old version was available through the option "Enable Multi-Record support"

[sub]

Sorry, there is no option for this. It's always enabled.

Is there something going wrong when you use this feature?

[ermac]

is the registration server crashes or does not register correctly (even in version 1.4 ...)

my setup includes:
2 WinTV Nova-t 500 pci

[sub]

What do you mean? I dont understand.

[ermac]

the problem with "multi-record" I had with version 1.4.7

is probably caused from the TV card that can not handle more than one stream, because each card has two tuners, for a total of four tuners

[sub]

Any digital card can handle more than one channel at a time. When you tune to a specific frequency, the device delivers the application all the data on that frequency (fata for multiple channels), the application throws away the data for the channels you're not interested in, and writes the data to disk for the channel you wanted to record. When its doing multi-record, its just throwing away less data.

Multi-record in 1.5.x works differently to 1.4.7, so you might find whatever problem you had on 1.4.7 is not an issue with NextPVR.

[ermac]

I noticed though that the problem always occurs when the more than two or three contemporary recordings on a single mux

[sub]

I still dont understand what the problem is. What happens? Do you see an error message, or something else?