USA Comcast QAM with Dvico Fusion 5 Express

[Hammerdown]

I have installed latest version of NPVR on XP Pro SP2. It does not show any QAM tuner. It shows two ATSC tuners and if I do a channel scan it does not find any channels.


I have two Dvico cards-
Fusion II - for over the air antenna DTV (nothing currently hooked up)
Fusion 5 Express - for QAM cable (comcast getting lots of channels with Fusion software)



How do I get NPVR to see the QAM tuner?

[sub]

Can you visit the Settings->Devices screen, then zip and attach the npvr.log?

[Hammerdown]

Thanks! Here is the log...

[sub]

That log doesnt show you visiting the Settings->Devices screen. Can you try again? You need to zip up the log immediately after visiting that screen. If you restart the app, the log messages I wanted to see from that screen would have been overwritten.

[Hammerdown]

Here's another log (looks the same to me).

Manually deleted NPVR log
Run NPVR
Settings
Devices
See log being created
Zip NPVR Log
Attach here

Is that right?

[sub]

Try this patch. You may need to delete the npvr.db3 first to force it to start with a clean database,

[Hammerdown]

Thanks! QAM Tuner(s) found, but channel scans come up with no channels found. Here is new Log after channel scan-

[sub]

Sorry, I dont know. As far as the app is concerned, everything looks fine, but device never manages to lock onto a signal.

I remember some old Dvico devices only supported QAM via their own software. Have you seen it work with other software that uses the Dvico BDA drivers?

[Hammerdown]

Some progress-
I ran the Dvico Fusion software, then closed it, then ran NPVR, then did a channel scan. It found all the right channels! Problem now is actually watching them... As soon as I select "Live Tv" it freezes and goes into Not Responding.

[Hammerdown]

Log after channel scan-