network recorder not showing in devices after following instructions

[douggoodwin]

I have windows7 and a ceton cable card. I read that the only cases of it successfully integrating with xbmc is in using npvr, network recorder, and sageDCT. After following the detailed pdf instructions in the wiki, I got stuck on the step of seeing the network recorder (NR) in the Devices of NPVR after installing it. If I am following it correctly, after puting the dll and xml NR files in the NPVR data folder, I should start NPVR and see it in the devices but it's not in there.
I started and stopped the NPVR service at the appropriate stages but I must be missing something. The xml file didnt get updated with a Network Recorder ID either.
Please help

[mvallevand]

Stop the recording service, and place the xml/dll file in

[DataDir]\Plugins\NetworkRecorder

Then continue from step 4 of installation http://www.nextpvr.com/nwiki/pmwiki.php?...order#toc5

Martin

[douggoodwin]

That's exactly what I did. Step 4 is where I got stuck. The network recorder is not in the devices of NPVR.

[mvallevand]

Compress and upload your npvr log file and I'll check.

Martin

[douggoodwin]

Where do I find the log file?

[mvallevand]

[DataDirectory]\Logs

Martin

[douggoodwin]

Here's my log

[mvallevand]

I wanted to see the npvr logs,

Martin

[douggoodwin]

The previous attachment was the logs. I thought it was the one you were asking for. I attached a screenshot of the folder in the zip file. I also attached a screen shot of where I am stuck. As you will see, the Network recorder files are located where the instructions directed but no device is in NPVR.

[mvallevand]

Something looks terribly wrong with your installation I am surprised NextPVR didn't give any error There should be more logs. Did you install all the prerequisites show on the wiki? If so could you delete npvr.db3, move the two files out of the NetworkRecorder folder and run the install again? The stop the service put the two files back.

Martin