Unable to find any channels

[Ericktreetops]

I removed my dual Hauppauge TV pci-e tuner card from one pc and placed it in the other. Then plugged in the aerial and tried to rescan the same channels it was using previously. However, no channels were found on the DVB-T tuners which were there in the old PC. The logs seem to shed no light on the issue. https://1drv.ms/u/s!ApXAQQ5XQRNGmQfc9Wach9hoc-un A few times I received a NextPVr error stating it could not find the devices so I reinstalled NextPVR. I haven't seen that error again but still the scan finds no channels. The Event viewer shows no errors or warnings. Device manager says tuner is working ok.

[sub]

Try doing an 'Australia / All Regions' scan, rather than your specific city. You're likely scanning the wrong frequencies.

[Ericktreetops]

I exported all the channels to an xml file before i pulled the card and swapped it out. Netxpvr couldn't find any of the channels when i imported them into the new pc. So i deleted the predefined channels and did a full re scan for Brisbane Australia which is where i live. Still no channels found. I then uninstalled NextPvr and deleted any files remaining. Then reinstalled and scanned again with the same result The only difference is they tv cable. I have the original pvr with a quad tunner workinng right next to it

[Graham]

Try doing an 'Australia / All Regions' scan, rather than your specific city. You're likely scanning the wrong frequencies.

... did a full re scan for Brisbane Australia which is where i live.

It is likely that the .ini file (from Users\Public\NPVR\Tuning\) is out of date and contains the wrong frequencies ... Try "All Regions"

[Ericktreetops]

All regions scan Australia . No channels found. Is t here a way to tell if t he device is actually getting any signals ?

[Graham]

All regions scan Australia . No channels found. Is t here a way to tell if t he device is actually getting any signals ?

Does this work with your tuner ... http://www.hauppauge.co.uk/site/support/...nitor.html

[sub]

All regions scan Australia . No channels found. Is t here a way to tell if t he device is actually getting any signals ?

Maybe check it in the Hauppauge WinTV software.

[Ericktreetops]

Thanks. Will download software after work today and see what i get

[Ericktreetops]

incorrect drivers. Signal monitoring tool doesn't work. Then downloaded the wrong LAV drivers. 64 bit not 32. Seems to be working fine now

[sub]

Great