Could not open NextPVR on 127.0.0.1 from Kodi on Sony TV with Android OS

[jksmurf]

Hi Martin,

I've been trying to get XNEWA working on my new Sony TV with Android OS [Sony Bravia KD-49X9000F (90F/900F)]
In doing so I have been relearning what I did for the RPi2 install, using your video, past notes etc.

I am now stuck at this message: Could not open NextPVR on 127.0.0.1 [from Kodi on Sony TV with Android OS]

• I disabled my firewall and tried - no go. See attached when running.
  
  
• I can access http://127.0.0.1:8866 (it goes to Guide.aspx) from the Server PC; but not from a notebook on the same Network, which says "connection refused"?
  
  
• Logs are attached.
  

I am not able to get you Kodi logs (at least I don't think so?) as I cannot SSH or WinSCP into the TVs OS.
Is there anything else you need me to do to help you here? DO I need to add the MAC address of the TV under clients e.g. so it goes into config.xml?

LATER: At some later stage, because I wish to autostart NextPVR and adjust the Guide.xml, I will also need to work out how to WinSCP into the TV Android system. I read this is possible with adb, and I tied that on port 5555 but got "Connection Refused". I have already enabled the developer option by pressing the lowest button in the 'About' "Build" menu 4 times and got the message it was enabled. There’s a New Android OS out for it shortly too Sony Bravia KD-49X9000F (90F/900F). Is this the correct way to access the advancedsettings.xml and guide.xml files I need to modify?

Cheers

k.

[EDIT] Ooops, reading this https://forums.nextpvr.com/showthread.ph...aded/page2, I think I need to check settings... if I can work out how to do that.

[jksmurf]

Hooray! fixed it. As per that last link I'd forgotten to configure XNEW Settings, so I added my Server IP Address in and bingo!
It did get stuck navigating with the higher OSD Screens, but appeared to work Ok when I backed that off. Screens are 1920x1080, but lower res.

I miss the blue button that brings up the timeline though. The Sony remote has them, but it doesn't bring up the OSD.