Ceton Infinitv4, Windows 10

[videolog]

Okay it is doing something. frame =.......
keeps scrolling

[mvallevand]

So hit ctrl-c to stop it and is there are videolog.ts file?

Martin

[videolog]

So hit ctrl-c to stop it and is there are videolog.ts file?

Martin

Where would it be, the normal recording directory? If so it is not there.

[mvallevand]

I would be in the folder where you ran the batch file or command

Martin

[videolog]

I would be in the folder where you ran the batch file or command

Martin

Users/Public/NPVR ?

[videolog]

Okay just for haha's I just tried in NPVR. tuned a couple of different channels. It is working. I think it may have had to do with changing the Opendct property from false to true.
Thanks for all your help. Now I just need to clean this up on my end.

Dave

[mvallevand]

That's positive news, I now need to update my script to turn off the logging, and make a note in the instructions to check the property for when I transfer this to the wiki.

You may want to check why you changed that property for SageTV, I confirmed the setting I used is the default.

For the browser test did you change the transcoder option or did it just work?

Martin

[jbhall56]

I have updated post #4 with a new file to be unzipped in the scripts folders.  Logging was already there.

@jbhall56 since you aren't seeing any extras file have you successfully run steps 5, 6 and 7 to install it.

Martin

Need to get your new zip file. As a "backup" I installed the 32-bit version just so I have my TV back. 

I tried to run steps 5 - 7 but again, saw no confirmation that anything had happened.

Will try again either today or tomorrow.

[mvallevand]

@Jeff you might as well keep using the debug version, the zip is fine until you are up and running

What do you see at the command prompt with

python opendct.py DISCOVERY

If nothing check that the "SageTV OpenDCT" service is running. The discovery protocol uses UDP port 8271 by default

Note trhis is only important if you aren't on localhost with port 9000. If you are using port 9000 and localhost with 8271 firewalled and port 9000 open for TCP you can still confirm OpenDCT with

python opendct.py VERSION

If that doesn't work no point in moving to step 7.

Martin

[videolog]

That's positive news, I now need to update my script to turn off the logging, and make a note in the instructions to check the property for when I transfer this to the wiki.

You may want to check why you changed that property for SageTV, I confirmed the setting I used is the default.

For the browser test did you change the transcoder option or did it just work? 

Martin

Hi Martin,
A little testing
If I change to true NPVR works Sage does not.
If set to False Sage works NPVR does not.

By default it is false per EnterNoEscape's documation

[*]"consumer.ffmpeg.upload_id_enabled=false
[*]consumer.raw.upload_id_enabled=false

[*]
[*]If set true, these will use the Media Server (upload id) feature of SageTV instead of writing directly to the file when recording."