2005-09-23, 10:42 PM
I changed addresses and cable and added a second address to my Zap2It thing. Since it was colliding, I removed the old one and tried removing and changing settings and readding etc. Anyway, it doesn't seem to work. When I initially add the capture source, it lists all the correct channels, but when I go to channels, it is still a mix.
Also, when I remove everything and close the config, it removes all the channels (at least I think--the web-based tv guide is empty). But when I go back into the config, there are two capture sources again and the channels are still there.
What should I do? I don't know where the channels are stored manually, but I guess deleting them if i could find them would be what i'd try.
Also, when I remove everything and close the config, it removes all the channels (at least I think--the web-based tv guide is empty). But when I go back into the config, there are two capture sources again and the channels are still there.
What should I do? I don't know where the channels are stored manually, but I guess deleting them if i could find them would be what i'd try.
