NPVR Synology Docker with Octopus SAT/IP finds no channels

[sub]

It doesn't look like that environment variable is set in the logs. I'd expected to see a "Downloading SAT>IP device description from http://192.168.178.20/octoserve/octonet.xml" message, but its not there in your logs.

[sub]

ie, ignoring the fact I did this on windows, you can see the type of message I'd expect to see if the environment variable was set in your docker container.

[sylvio2000]

Thats really strange. Maybe do I have a syntax error in my commands? For now it looks like this:

docker run -d --volume /volume1/docker/nextpvr/Aufnahmen:/recordings --volume /volume1/docker/nextpvr/Aufnahmen:/buffer --volume /volume1/docker/nextpvr/config:/config --restart unless-stopped --net=host --env SATIP_DEVICES=http://192.168.178.20/octoserve/octonet.xml --publish 8866:8866 --publish 16891:16891/udp nextpvr/nextpvr_amd64table

[sylvio2000]

Ok, I am a step further

I created a new container in bridge mode, but with --env SATIP_DEVICES=http://192.168.178.20/octoserve/octonet.xml.
Now I can see all 4 tuners, but if I click on them I get the error: 192.168.178.10 declined the connection (this is my synology)

edit: I restarted the container and now I can scan for channels. I keep you updated

Update1: No channels found 

[sub]

Try the scan, and post the logs and we'll take a look.

[sylvio2000]

Update2:

I created a new container with the only difference, thats its now in host mode (again). I thought it is now as before, BUT now channel scan works? Found over 1000 channels. This is absolutely confusing. 
Does it make any difference in which order the ssh commands are send?

Now my working commands are:

docker run -d --volume /volume1/docker/nextpvr/Aufnahmen:/recordings --volume /volume1/docker/nextpvr/Aufnahmen:/buffer --volume /volume1/docker/nextpvr/config:/config --restart unless-stopped --env SATIP_DEVICES=http://192.168.178.20/octoserve/octonet.xml --net=host --publish 8866:8866 --publish 16891:16891/udp nextpvr/nextpvr_amd64table

[mvallevand]

It could simply be the SAT>IP improvement in 5.2 are working for you.

Martin

[sylvio2000]

Could be.

EPG Update is not working. Behind every device there is a message: (unavailable). And if I try to start a channel it says: Streaming failed (Transcoder exited).
Seems I have no access to the devices. TVMosaic is already stopped.

Here is the latest log.

[mvallevand]

Are you host mode or bridged now? It is hard to keep up.

Martin

[sylvio2000]

Now I am in host mode with additional command: --env SATIP_DEVICES=http://192.168.178.20/octoserve/octonet.xml