EPG Information truncated

[mvallevand]

I agree I don't know the syntax but my point was the pids=all option is not supported by all SAT>IP devices.

On ffmpeg 4.3 I get the same error as you on ffmpeg 5.1 and above I do not. I do get the same error if I provide an invalid rtsp_flag though.

Martin

[mvallevand]

I setup minisatip to see if I could get a full mux from ATSC and it worked fine with ffmpeg, or at least OTA data was available in the full mux

I did have to change the syntax for your desired frequency as follows

Code:

ffmpeg -rtsp_flags satip_raw -i 'satip://192.168.10.1:554/?freq=474&msys=dvbc&mtype=qam256&pids=all' -map 0 -c copy -f data -y fullmux.ts

If there are problems you might also need &sr=6900 again assuming the Fritzbox accepts &pids=all

Using 4.3.8 which you used both -rtsp_flags satip_raw and the satip protocol failed so I still expect you need ffmpeg 5.1 or higher.

Martin

[Marty56]

Not working, satip protocol not recognised.
I replaced it with rtsp but this revealed the syntax error.

I give up meanwhile and will wait a couple of months. Tvheadend is anyway still working so no need to rush.

Thanks for the trying.

[mvallevand]

Right as noted above both of those error are because you are using ffmpeg 4.3.8. With a modern Linux distro, macOSE or Windows things would work differently.

If you just have the one PC in the house and it runs Debian 11 maybe try a boot USB with Linux or LibreELEC 12 as I suggested earlier.

Martin