NPVR Synology Docker with Octopus SAT/IP finds no channels

[sylvio2000]

First I have to say that the digibit r1 works with tvheadend and docker



OK, I tried this and it did not work:


docker run -d \

--name nextpvr \

--volume /volume1/docker/nextpvr/config:/config \

--volume /volume3/Filme/Aufnahmen:/recordings \

--volume /volume3/Filme/Aufnahmen:/buffer \

--restart unless-stopped \

--net=host \

nextpvr/nextpvr_amd64table

Then I tried the bridge mode with the udp port 1901. But here I get the following error:

Standardausgabe/Fehler:
19db277d6309c0ada33efd215cebd0cf08c06d94873f1863a29eed46639efad7
docker: Error response from daemon: driver failed programming external connectivity on endpoint nextpvr (1e0c97cf994162d8e0f201d969c784a5d3fb26585a1f2252afe3c3994c8b47c8): Error starting userland proxy: listen udp4 0.0.0.0:1901: bind: address already in use.

docker run -d \

--name nextpvr \
--volume /volume1/docker/nextpvr/config:/config \
--volume /volume3/Filme/Aufnahmen:/recordings \
--volume /volume3/Filme/Aufnahmen:/buffer \
--restart unless-stopped \
--publish 8866:8866 \
--publish 1901:1901/udp \
nextpvr/nextpvr_amd64table

S

[ben-no]

Dear all,

I experienced a similar problem (https://forums.nextpvr.com/showthread.ph...069&page=2). In host mode, it works fine. Do you know what need to be done to get it working in bridge mode?

[mvallevand]

It is explained earlier in this thread but I just setup a Docker trying to call minisatip and the client_port NextPVR uses is not fixed. For bridged modes those ephemeral ports would need to be configured in the run command which cannot be done.

Code:

2024-01-19 20:01:13.877    [DEBUG][78]    About to scan: rtsp://172.16.3.145:554/?freq=57&bw=6&msys=atsc&mtype=8vsb&wait=0&pids=0,8187
2024-01-19 20:01:13.880    [VERBOSE][78]    
SETUP rtsp://172.16.3.145/?freq=57&bw=6&msys=atsc&mtype=8vsb&wait=0&pids=0,8187 RTSP/1.0
CSeq: 1
User-Agent: NextPVR
Transport: RTP/AVP;unicast;client_port=38037-38038

Martin