Win TV Dual HD tuner

[RichRail]

Hi Everyone
I'm very much new to this so please excuse the question if I'm a dummy!
I have a Hauppauge WinTV Dual HD plugged in to my Windows 11 PC.
Next PVR is setup and working.
I have scanned and saved each tuner and updated both with the relevant EPG and saved.
However when I go into TV Guide I get all of the correct information for the 1st tuner OK
Underneath each channel I assume I get the other tuner information but only see "No Listings" for every channel, no programme info.
I'm sure I should be seeing the programme data duplicated for 2nd tuner?
Hope this makes sense and any assistance much appreciated.
Rich

[mvallevand]

Normally you don't scan each tuner separately, (you can't mix DVB-T and DVB-C AFAIK) you scan one and open the second you copy to see only one channel in the guide. Why do you want to see them twice?

Martin

[sub]

Yeah, delete the channels off the second tuner, then click that tuner to set it up again, and accept it's offer to copy the channels off the existing tuner. This way you only end up with a single copy of the channels, each available from two sources.

[RichRail]

Thanks, I'll give it a try
Rich

[mvallevand]

To delete from tuner 2 when you open it there is a trash can. Click it close and the copy when you reopen it.

Martin