Python Missing from 7.0.0.241105

[pkscout]

I updated to 7.0.0.241105 in Docker, and it seems Python (and pip) is no longer included.  Or at least I can't find it.  I didn't see anything about that in the release notes, and without Python my entire workflow is broken.  I guess I'll have to dig up the Docker stuff I did to add python to NextPVR and go back to maintaining my own image.

[mvallevand]

Was python included before or did you add it. You can just run a bash shell into Docker and add it to sub's It is pretty hard to add all the pip requirements needed for python to make it worthwhile.

Martin

[pkscout]

At some point it got added, because I stopped maintaining my image specifically because the default image had Python. And now it's gone. I'm manually adding stuff for now, but adding stuff to the image after it's been downloaded is the worst possible way to manage a Docker image. So tomorrow I'll go back and build my own image again.

[mvallevand]

I just find it odd that the python modules that you said were included where the same ones that you installed here https://forums.nextpvr.com/showthread.ph...#pid529636 there are so many others that many python users might want.

When I used Docker I just put a script in config that I ran each release. You could even script PreStartup.sh to do it for you.

Martin

[pkscout]

It wasn't any of the modules, it was just Python3 and pip. They were on the image, and now they aren't. It's fine. I'll look at using PreStartup.sh to add Python and pip. That's not a bad way to handle it.

[mvallevand]

OK since you like most users still have to use pip the script makes more sense anyway.

Martin