NO DVB-T EPG Scan

[jcjefferies]

Martin
Most channels uses the Freesat EPG but unable to detect the few clear channels on SKY transponders so have to use DVB-T version. However recently NextPVR has occasionally not done a DVB-T update but now just does the Freesat Scan. Under "EPG Sources" the  DVB EPG source is listed!
Enclosed is log file created after a EPG Update.

Chris

[mvallevand]

Could you zip up and send your /storage/.kodi/userdata/addon_data/service.nextpvr/config/adapter*.conf files. That is where the issue lies.

I will try and create some DVB-S ini file for you using a work in progress utility I have. Partially related to this utility do you know your bouquet numbers https://mizar.mythtv.org/wiki/DVB_UK?

Finally it looks like you did a manual update of LE to to 7.0.3 which is fine and I will updating the addon soon for manual updates soon. It does look like your DVB-S signal is weak and there are notable errors getting the EPG.

Martin

[jcjefferies]

Thanks Martin 
Enclosed is requested zip file.
The Region is West/West Region 20 or 21 the Chanel 4&5 regions are only for adverts!
I am reasonably sure I did the update to v 7.0.3 from the Welcome web page in the last few weeks. Looking at LibreElec add-ons/services/NextPVR Server the version on offer there is 7.0.1-2 so would not have used that.
One or two HD channels have had occasional signal breakup but since I started using the much newer PC that seems to have gone. However I do have a second larger dish which I connected Tuner 1 to some weeks ago and not seen any breakup. That dish has been setup with a signal strength meter!
One of the reasons I bought a WinTV-NOVA-S2 which you have seen elsewhere was to see if it sorted the occasional signal breakup which I was having with my SAT>IP tuner. 

Chris

[mvallevand]

Ok so there is no adapter1 conf file. Maybe you never initialized it? Go into adapter 1 and copy it when it asks.

There are a lot of mpeg ts errors on the Freesat guide.

I'm glad you manually updated to 7.0.3 no worries there.

Martin

[jcjefferies]

Thanks Martin that cured the problem! I dont know how adaptor1 missed being initialised as it had more channels than adaptor0. I moved adaptor1 to being top the list several days ago after adding more channels after a scan. So its obviously not been enabled since I moved to the newer PC!
Thanks Again!

Chris