Streaming Failed (transcoder exited)

[Fender_Bender66]

Hello,

I am able to watch and record TV using WinTV 10, but nothing with NextPVR. Error message "Streamig Failed (transcoder exited). Video Encoder is set to CPU.
When using the NextPVR Windows client, I get a few seconds of sound and then a box that says "...please wait..." that never goes away and no picture appears. Doing this seems to load a one minute clip in the Pause Buffer directory, which has proper audio and video from that channel.
Any advice would be appreciated. Log Files attached. Thanks

Setup: Hauppauge HVR-1265 - 57 OTA ATSC Channels are programmed and EPG is loaded.
          Hauppauge WinTV 10  installed
          HP p7-1154 AMD A6-3600, 14 GB RAM
          MS Win 10 Pro 64-bit
          Firefox browser (Chrome and Edge have same result)

[mvallevand]

Are you sure you unblocked audio and video playback in the browser?

Martin

[Fender_Bender66]

Yes, "Allow Audio and Video" is selected in the Firefox browser address bar. I also tried using Chrome and Edge with the same result. I have been able to get the NextPVR Windows app to work after loading and selecting the LAV drivers, as suggested elsewhere in this forum. But always the same error when trying to open from a browser.

[mvallevand]

I see you reduced the default slip buffer notably maybe too low for streaming maybe try the default 1200.

Martin

[Fender_Bender66]

Martin - I assume you mean 20 minutes for the pause buffer? (1200 seconds) Well I have since removed and re-installed Next PVR, so everything should be set to the default. Still having the same issue, but now also the added problem of EPG not updating properly. As an experiment, before un-installing and re-installing, I tried recording a 30 minute show. The recording came out fine, I can watch it in the Win client, but not in the browser.

[mvallevand]

Without logs there are no problems.

Martin