2006-02-22, 05:17 AM
I have a PVR-250 fitted with the Hauppauge second input board. This is a small board on a backplate connector that plugs into the white connector on most Hauppauge boards. I provides a second composite/svideo input plus stereo audio. I am using this input in addition to the standard one provided on the PVR-250 itself.
I have channel 1 configured as Svideo, and channel 2 configured as Svideo2. No other channels are configured. On either channel, the audio output is from the audio input on the PVR-250 (corresponding to channel 1). The video switches normally. If I add a channel from the Hauppauge on board tuner, the audio will switch properly to the tuner and then back to audio 1 for channel 1 and audio 1 for channel 2.
Using the Hauppauge WinTV software, the video/audio switches properly, so I don't think I have a hardware problem.
Any help would be greatly appreciated.
-Mike
I have channel 1 configured as Svideo, and channel 2 configured as Svideo2. No other channels are configured. On either channel, the audio output is from the audio input on the PVR-250 (corresponding to channel 1). The video switches normally. If I add a channel from the Hauppauge on board tuner, the audio will switch properly to the tuner and then back to audio 1 for channel 1 and audio 1 for channel 2.
Using the Hauppauge WinTV software, the video/audio switches properly, so I don't think I have a hardware problem.
Any help would be greatly appreciated.
-Mike