technotrend DBV-T USB Stick

[donmiguel]

Hi all,

I am using a technotrend DVB-T USB stick and managed to get it working with this config:

bda.ini:
[USB2.0 BDA DVB Capture]
TUNING_TYPE=DVB-T
FILTER_TUNER=USB 2.0 BDA DVB-T Tuner
FILTER_CAPTURE=USB 2.0 BDA DVB Capture
PIN_TUNER_IN=Input0
PIN_TUNER_OUT=MPEG2 Transport
PIN_CAPTURE_IN=MPEG2 Transport
PIN_CAPTURE_OUT=MPEG2 Transport

GB-PVR Configuration:
EPG Source: DVB EPG Broadcast


When I run "Map digital channels to EPG channels" I am unable to find all TV channels, only a few, and some are labelled "unknown". I suppose this is due to bad receipt of the card.

I am using an active antenna, which is usually powered with 5V from the technotrend USB stick. Unfortunately I did not find a way to turn on the 5V power supply from within GB-PVR.

Is there a way to modify some config to turn on the 5V power supply for the external active antenna? :confused:

Many thanks,

donmiguel

[sub]

I am using an active antenna, which is usually powered with 5V from the technotrend USB stick. Unfortunately I did not find a way to turn on the 5V power supply from within GB-PVR.

Is there a way to modify some config to turn on the 5V power supply for the external active antenna?

No, there isnt anyway to do this in GB-PVR. Its certainly not part of the BDA spec. It must be something proprietary to this specific device.