2006-07-11, 06:14 PM
My GB-PVR is newly installed, and just refuses to beleieve that any channels have been set up for my hardware. I'm using an AF9005 USB Device, and Windows reports no problems with the drivers off the CD. I've changed the thingymajig int the bda.ini file to read:
[AF9005 BDA Device DVB-T USB]
TUNING_TYPE=DVB-T
FILTER_TUNER=AF9005 BDA Tuner Filter
FILTER_CAPTURE=AF9005 BDA Capture Filter
PIN_TUNER_IN=Input0
PIN_TUNER_OUT=MPEG2 Transport
PIN_CAPTURE_IN=MPEG2 Transport
PIN_CAPTURE_OUT=MPEG2 Transport
I've set the EPG Source to map only BBC1, BBC2, ITV and Channel4 (I'm in the UK, obviously), and then I click the "Updage EPG" button on the "Edit Recourding Source" page, and it takes a while and then gives me the 4 channels in the relevent box in the same page. This is where it starts going wrong/weird.
The checkbox "Enabled" is unchecked for each of the four channels, so I try to tick the boxes, and then click OK. When I open up the edit page again, the checkboxes are cleared. Also, when I go to the "Channels" tab in the main configure program, they're all there.
So, what's going on? Any help?
[AF9005 BDA Device DVB-T USB]
TUNING_TYPE=DVB-T
FILTER_TUNER=AF9005 BDA Tuner Filter
FILTER_CAPTURE=AF9005 BDA Capture Filter
PIN_TUNER_IN=Input0
PIN_TUNER_OUT=MPEG2 Transport
PIN_CAPTURE_IN=MPEG2 Transport
PIN_CAPTURE_OUT=MPEG2 Transport
I've set the EPG Source to map only BBC1, BBC2, ITV and Channel4 (I'm in the UK, obviously), and then I click the "Updage EPG" button on the "Edit Recourding Source" page, and it takes a while and then gives me the 4 channels in the relevent box in the same page. This is where it starts going wrong/weird.
The checkbox "Enabled" is unchecked for each of the four channels, so I try to tick the boxes, and then click OK. When I open up the edit page again, the checkboxes are cleared. Also, when I go to the "Channels" tab in the main configure program, they're all there.
So, what's going on? Any help?