channels freqs for Belgium

[biamont]

Dear,

After some problems with the database, I finally managed to re-install GB-PVR.
However, I've lost the channels (frequencies) for Belgium.
I remember I had a very long time to get them last time... and i did not make a backup...

If anyone has some info about this, please help me.

thank you
vincent

Hauppauge TV PVR-USB2

[HtV]

You could use the tuning-assistant and write down the frequencies, then after that enter them in the config-channel-list.

[biamont]

hi Htv,

thanks, but the channel numbers do not work,I need freqs

Sorry,I do thing the wrong order: Now, I searched the forum for 'Belgium' and found back my post of last year (http://forums.nextpvr.com/showthread.php...ht=belgium)
si I'll try to read it again and there should be the solution...

sorry
vincent

[HtV]

Afaik, the tuningassistant gives frequencies aswell.

[thysdavi]

Vincent,

Had some troubles with this in the past. And therefor wrote these down in a file. These are the one's I use:

Eén = 24
KETNET/Canvas = 28
VTM = 21
Kanaal 2 = 34
VT4 = 33
Ned 1 = 22
Ned 2 = 20
Ned 3 = 18
TMF = 37
CNN = 23

Regards,

David

[biamont]

Dear,
I get back my backup of the old install
I checked the config.xml and the old ACCESS database : inside the table Source_Channel_mapping, I found the frequencies. they match my current freqs. (I don' know for the channel numbers...)

So I believe I'm missing something other.
I guess something is wrong for the recording device "Direct recording Configuration" panel:
The card type is hauppauge PVR USB2
I'm not sure of the 'source' setting. I guess I tried them all.

are there other settings?
I strongly believe my decoder etc settings are good since they wee copied from my old release backup.

If someone has a PVR USB2, it would be nice to publish his/her settings.

thanks for your help
vincent