2008-03-28, 11:18 PM
dear Frank Z,
I hope you can offer some help, i have been trying everything to get my setup working - i think i have aready and tried all your posts and Wiki's, not sure what am i missing?.
I have a H4 MVP (via UTP), using the latest versions of GBPVR and Zprocess.
Router is a wrt54gs (running dd-wrt, but test all sorts of other firmware.)
Laptop is a winXP (all updated SP's), 1Gb ram, p4 M 2.4Ghz. tested via 54g wifi and 100mb wired.
I cannot initiate a transcoding via the MVP. It works fine when i test everything via the zproccess2.exe interface and also if i execute the runtranscode.cmd file.
The error after a failed request from the MVP seems very similar in all cases, i have attached some log for you to see. "Transcoder died early.."
Some of the other tests - with the same error:
I have tried both the trans2mvp.exe install and the .reg type install
I have played with the pre-start delay times and pushed to max
I have tried mplayer rc1 and 3,
ffmpeg (stock version and your suggest version),
i have also tried VLC.
excutting "RunTranscode.cmd" on the PC and the transcodeing fires off and runs perfectly - producing a correct output file.
Moved and renamed files to 8.3 standard (file and directory)
Any thoughts i what else i can try?
S.
I hope you can offer some help, i have been trying everything to get my setup working - i think i have aready and tried all your posts and Wiki's, not sure what am i missing?.
I have a H4 MVP (via UTP), using the latest versions of GBPVR and Zprocess.
Router is a wrt54gs (running dd-wrt, but test all sorts of other firmware.)
Laptop is a winXP (all updated SP's), 1Gb ram, p4 M 2.4Ghz. tested via 54g wifi and 100mb wired.
I cannot initiate a transcoding via the MVP. It works fine when i test everything via the zproccess2.exe interface and also if i execute the runtranscode.cmd file.
The error after a failed request from the MVP seems very similar in all cases, i have attached some log for you to see. "Transcoder died early.."
Some of the other tests - with the same error:
I have tried both the trans2mvp.exe install and the .reg type install
I have played with the pre-start delay times and pushed to max
I have tried mplayer rc1 and 3,
ffmpeg (stock version and your suggest version),
i have also tried VLC.
excutting "RunTranscode.cmd" on the PC and the transcodeing fires off and runs perfectly - producing a correct output file.
Moved and renamed files to 8.3 standard (file and directory)
Any thoughts i what else i can try?
S.