Config crashes when mapping channels

[soundman]

Upgraded to v1.2.13 last week. Came back home and tried to map the digital channels to EPG in config (different trasmitter at home!) and it crashes every time on 6 out of 6.

Attached are my logs.

Any ideas?

DVB-T tuner is a Hauppauge WinTV Nova-T usb stick ( Tried both Type 3 and Type 5)

[Pob]

Upgraded to v1.2.13 last week. Came back home and tried to map the digital channels to EPG in config (different trasmitter at home!) and it crashes every time on 6 out of 6.

Attached are my logs.

Any ideas?

DVB-T tuner is a Hauppauge WinTV Nova-T usb stick ( Tried both Type 3 and Type 5)

Just saw your post - I have exactly the same problem, with the same Nova-T stick. The upgrade of my existing GBPVR to 1213 went fine, but installing it on a new PC crashes each time I try to scan.
Please let me know if you found a fix.

[Kettler1701]

Also experiencing this problem, after a bit of testing I was able to get it to scan all frequencies without it crashing, however it did not detect all the channels, some appear to be missing.

I changed a lot of settings before I got it to work so not 100% sure that the following options will work but these were the last settings I changed, let me know if any help you.

<BDAAutoScan166KHzOffset>false</BDAAutoScan166KHzOffset>
<BDAIgnoreRadioDuringChannelScan>false</BDAIgnoreRadioDuringChannelScan>
<BDAIgnoreHiddenChannels>false</BDAIgnoreHiddenChannels>

If none of those work I will try to find what else I changed.

[Pob]

I uninstalled 1213 on my new PC and installed the previous release 10209:
http://forums.nextpvr.com/showthread.php?t=33735
And it scans everything without a problem.
So does appear to be an issue with 1213. Once all the channels are scanned upgrading to 1213 seems to go without problems, but cannot verify this 100%as before my Nova stick was the recording tuner, not the live TV tuner.
Pob

[soundman]

Tried the things Kettler1701 suggested but no luck. Have followed Pob's route and installed 10209, got the channels sorted, then upgraded to 10213. All works now - very odd!

[garymeds]

i have same issue, but don't want the hassle of going through setting up 10209 - is there a fix for this or if i install lower version over the top, will it be ok?