PVR150MCE Doesn't pickup many channels

[chenko]

When doing an autoscan (In the hauppauge wintv program) it only picks up about 5-6 channels, and it misses a few of the main 5, using a freeview DVB box on this antenna works perfectly, just rewired the whole house with a new booster and the signal is perfect and freeview works in any room, yet the card only picks up a few...

[reven]

switch to cable, not antenna (antenna only picks up a few frequencies).

[chenko]

I tried Cable and that only got me 6 bad quality channels, though Ive just used the "Cable HRC" and it did a scan from 1 to 125 and picked up a channel for everyone each of them all the same channel



Tuning Mode: Channels By Country
Country: United Kingdom
Broadcast/Cable: Cable (HRC)
Tuner Format: I
Video Format: PAL BGHIDK

HRC-1 to -125 all the same channel


Tuning Mode: Channels By Country
Country: United Kingdom
Broadcast/Cable: Cable
Tuner Format: I
Video Format: PAL BGHIDK

Cable-4, 41, 44, 47, 51, 54 (4 is just static, others are ok)

Tuning Mode: Channels By Country
Country: United Kingdom
Broadcast/Cable: Antenna
Tuner Format: I
Video Format: PAL BGHIDK

Ant-22, 23, 25, 28, 32, 35, 70 (70 is just static)


I've also tried the "All Channels" setting over the "Channels by Country"

Tuning Mode: All Channels
Country: N/A
Broadcast/Cable: N/A
Tuner Format: I
Video Format: PAL BGHIDK

Picks up 7 channels, all static or b&w


This is in the Hauppauge Suite Manager btw, ive just noticed the Tuning Assistant with GB-PVR so I am just going to give that a try now...

[sub]

Is it possible you only actually receive 5-6 analog channels? The freeview box is digital, and picks up digital channels, which you're obviously not going to be able to tune in using your PVR150MCE.

[chenko]

My stupid, getting mixed up with the external box and was treating my card as a dvb card, duh