2008-09-07, 08:32 PM
GBPvr v1.2.13
Tuners - Cinergy 2400i Dual Tuner
Tuners work with Terratec Home Cinema and VMC
I am looking to move from VMC to GBPvr and installed software and started to configure tuner.
Terratec Cinergy 2400i DT #1 DVB-T and Terratec Cinergy 2400i DT #2 DVB-T both detected OK
Set up both device as #1, set transmitter as UK Crystal Palace
Run Map Digital channels to EPG channels and after initialisation, and scanning with zero signal, reported "No channels found. Please check your signal and configuration settings"
Repeated with different Terratec BDA drivers
Driver 284 - No channels
Driver 283a - No channels
Driver 260 - No channels
Driver 255 - Channels found but reported error before finishing
Channels found on 1, 2, 3, 4, 5 but on 6 error message
".NET Framework
Unhandled exception has occurred in your application ...
Attempted to read or write protected memory. This is often an indication that other memory is corrupt"
Then another error message
"GB-PVR Configuration error - has encountered a problem and needs to close"
and closed
Reloaded and repeated scan with same error.
Please advice on configuring GBPvr with the Cinergy 2400iDT dual tuner.
David
Tuners - Cinergy 2400i Dual Tuner
Tuners work with Terratec Home Cinema and VMC
I am looking to move from VMC to GBPvr and installed software and started to configure tuner.
Terratec Cinergy 2400i DT #1 DVB-T and Terratec Cinergy 2400i DT #2 DVB-T both detected OK
Set up both device as #1, set transmitter as UK Crystal Palace
Run Map Digital channels to EPG channels and after initialisation, and scanning with zero signal, reported "No channels found. Please check your signal and configuration settings"
Repeated with different Terratec BDA drivers
Driver 284 - No channels
Driver 283a - No channels
Driver 260 - No channels
Driver 255 - Channels found but reported error before finishing
Channels found on 1, 2, 3, 4, 5 but on 6 error message
".NET Framework
Unhandled exception has occurred in your application ...
Attempted to read or write protected memory. This is often an indication that other memory is corrupt"
Then another error message
"GB-PVR Configuration error - has encountered a problem and needs to close"
and closed
Reloaded and repeated scan with same error.
Please advice on configuring GBPvr with the Cinergy 2400iDT dual tuner.
David