Ok I've read just about every M780 post that had a question about anything. I've learned a lot, but apparently not enough to complete the simple task of adding my Aver M780 to the device config properly.
My symptoms:
After adding AverMedia M780 (Analog) to the Recording Source, Setting up Schedules Direct I am able to update the EPG. When I open PVRX2 I am able to see my channel lineup in the "Guid" however, after selecting a channel and pressing "Watch" I am only presented with a black screen and no audio, then shortly there after (within 3 seconds) I am kicked back to the guide screen.
What I've done.
Using the Tuning Assistant I've been able to see all the cable channels I want to use, therefore I know the card is functioning properly.
What I need to know:
Why on earth I cannot get PVRX2 to display the same channels the tuning assistant will.
I'm terribly sorry for the newbie question, but this is my first time using GBPVR.
I've also attached a copy of my PVRX2 logs in hopes that perhaps someone can determine what's wrong.
My symptoms:
After adding AverMedia M780 (Analog) to the Recording Source, Setting up Schedules Direct I am able to update the EPG. When I open PVRX2 I am able to see my channel lineup in the "Guid" however, after selecting a channel and pressing "Watch" I am only presented with a black screen and no audio, then shortly there after (within 3 seconds) I am kicked back to the guide screen.
What I've done.
Using the Tuning Assistant I've been able to see all the cable channels I want to use, therefore I know the card is functioning properly.
What I need to know:
Why on earth I cannot get PVRX2 to display the same channels the tuning assistant will.
I'm terribly sorry for the newbie question, but this is my first time using GBPVR.
I've also attached a copy of my PVRX2 logs in hopes that perhaps someone can determine what's wrong.
