setup required chinese DM1105 Sat PCI Card

[bdgillard]

I have purchased a Hong Kong sourced satellite tv card purchased from ebest24.com and I don't know the settings to add it to the BDA.ini file
can anyone help please?
the filtercheck.log is below
thanks

12:06:13.435 INFO Log started
12:06:13.435 INFO Filter Check v1.0
12:06:13.435 INFO
12:06:13.435 INFO
12:06:13.435 INFO Checking AM_KSCATEGORY_CAPTURE filters
12:06:13.450 INFO
12:06:13.450 INFO
12:06:13.450 INFO Checking AM_KSCATEGORY_ENCODER filters
12:06:13.450 INFO
12:06:13.450 INFO
12:06:13.450 INFO Checking AM_KSCATEGORY_CROSSBAR filters
12:06:13.450 INFO
12:06:13.450 INFO
12:06:13.450 INFO Checking AM_KSCATEGORY_TVTUNER filters
12:06:13.450 INFO
12:06:13.450 INFO
12:06:13.450 INFO Checking AM_KSCATEGORY_TVAUDIO filters
12:06:13.450 INFO
12:06:13.450 INFO
12:06:13.450 INFO Checking AM_KSCATEGORY_VBICODEC filters
12:06:13.466 INFO
12:06:13.466 INFO
12:06:13.466 INFO Checking KSCATEGORY_BDA_NETWORK_TUNER filters
12:06:13.466 INFO found: DM1105 DVBS BDA Tuner Filter
12:06:13.466 INFO - (input) Input0
12:06:13.466 INFO
12:06:13.466 INFO
12:06:13.466 INFO
12:06:13.466 INFO Checking KSCATEGORY_BDA_RECEIVER_COMPONENT filters
12:06:13.482 INFO found: DM1105 DVBS BDA Capture Filter
12:06:13.482 INFO - (input) Input0
12:06:13.482 INFO - (output) Capture
12:06:13.482 INFO

[sub]

Try adding this to your bda.ini file:

[DM1105 DVBS]
TUNING_TYPE=DVB-S
FILTER_TUNER=DM1105 DVBS BDA Tuner Filter
FILTER_CAPTURE=DM1105 DVBS BDA Capture Filter
PIN_TUNER_IN=Input0
PIN_TUNER_OUT=MPEG2 Stream
PIN_CAPTURE_IN=Input0
PIN_CAPTURE_OUT=Capture

[bdgillard]

Try adding this to your bda.ini file:

[DM1105 DVBS]
TUNING_TYPE=DVB-S
FILTER_TUNER=DM1105 DVBS BDA Tuner Filter
FILTER_CAPTURE=DM1105 DVBS BDA Capture Filter
PIN_TUNER_IN=Input0
PIN_TUNER_OUT=MPEG2 Stream
PIN_CAPTURE_IN=Input0
PIN_CAPTURE_OUT=Capture

Thanks, worked a treat, unfortunately the card is faulty, will not switch polarisation

[borgrail]

Hi

Probably a very silly question but just where should the bda.ini file be located? I have been unable to find it thus far.

[johnsonx42]

the bda.ini file is only used by the old gb-pvr program (which would be in c:\program files\devnz\gbpvr IIRC). Digital device detection is automatic in NPVR. The 2nd post of the thread linked in my signature will tell you where various npvr files are, but there's no bda.ini any more.