Map Channels Manually

[jtokach]

Hi. My cable provider recently switched our channels around and GBPVR isn't picking up a single channel in scans anymore, I don't know why. WinTV found the new channels. I found some threads on here about mapping them manually, downloaded TSReader, but I can't figure this out nor get TSReader working.

The new channels are:
117.1701
82.1601

I don't know how to derive the remaining info.

Thanks for your help!

[sub]

Trying to map channels manually is not straight forward, and I dont have any pre-prepared instructions for how to do this. You'd definitely need to get TSReader working though.

Alternatively, if you do a scan in GB-PVR, and post the config.exe.log and config.exe-native.log, I'll see if there is any obvious reason these new channels arent appearing for you.

[jtokach]

Thanks for taking a look Sub. I don't know how to setup TSReader... I have a 2250 and tried a few of the options during the startup, but they didn't work. Is there a guide here or somewhere to set it up and some basic usage? Does it work with the 2250?

[sub]

I have a 2250 and tried a few of the options during the startup, but they didn't work. Is there a guide here or somewhere to set it up and some basic usage? Does it work with the 2250?

Sorry, I dont know. I've never used it with a QAM/ATSC device. I just use it for looking at recordings that people supply me.

I'll take a look at that log.

[sub]

Those scans shown in your logs look like they didnt find any channels? Not just two missing channel.

[sub]

2010-03-19 20:51:02.041 VERBOSE FindFilterByName failed to locate filter: GB-PVR PSI Parser

Try running ReRegisterFilters.bat, then scan again.

[jtokach]

That did it Sub, thanks. Sent a little something. Go get a beer or two on me.