NMT Syntax check

dslowik · 2010-06-12, 03:02 AM

I've been primarily using one NMT (PCH) and finally got around to running cables for the second one. They both work using the network browse method, but I was going to change them over to make it auto load based on the scripts Jaggy put on the wiki. Before doing that I decided to run the NMT Checker on both IP's to make sure everything was ok and that I didn't mess anything up. I noticed that when putting in one IP, it makes it further than the other. Attached is the output from each run and also my config.xml.

Thanks,
David

mvallevand · 2010-06-12, 03:16 AM

A few things

1 Change
<a href="http://localhost.drives:8883/NETWORK_SHARE/PVRPC:mvpmc/gbpvr.cgi">GB-PVR</a>
to
<a href="http://localhost.drives:8883/NETWORK_SHARE/pvrpc:mvpmc/gbpvr.cgi">GB-PVR</a>

2. The web server is not enabled, you might need to tell the recording service to enteract with the desktop

3. NMT-81 doesn't look like it has an mvpmc share (or it is using old firmware)

Martin

dslowik · 2010-06-12, 04:13 AM

mvallevand Wrote:1 Change
<a href="http://localhost.drives:8883/NETWORK_SHARE/pvrpc:mvpmc/gbpvr.cgi">GB-PVR</a>

2. The web server is not enabled, you might need to tell the recording service to enteract with the desktop

3. NMT-81 doesn't look like it has an mvpmc share (or it is using old firmware)

Martin

Wow! You can tell a bunch of stuff from that log. I changed number 1 and you were correct about NMT-81. It did not have a share configured, but it does now. Number 2 I am not sure about. The recording service is set to interact with the desktop and I use the EWA occasionally to set things up, so I am pretty sure the web server is enabled. I just verified that EWA is working. I also just noticed the logs do say "WebServerEnabled true."

I just checked and I can now start both NMT's from the Network Share link rather than the browser, so I think I have success and can work on the auto load soon!

Thanks,
David

mvallevand · 2010-06-12, 04:33 AM

Ah yes, looking again I can see that you have a password on your web server. I don't know if that will get in the way or not.

Martin

dslowik · 2010-06-12, 04:41 AM

I didn't think about that - I'll remove it just in case.

Thanks,
David

Possibly Related Threads…
Thread		Author	Replies	Views	Last Post
	NMT syntax checker, What did I do wrong	ricksuper67	11	16,020	2013-11-09, 05:01 AM Last Post: ricksuper67
	Sanity Check on my setup and MVPMCX2	jt25741	16	5,318	2011-03-23, 02:52 AM Last Post: mvallevand
	NMT Syntax Checker	mvallevand	6	284,031	2010-09-25, 03:43 AM Last Post: mvallevand