Hauppauge HDPVR channel changer not sicking in 2.03

[Northpole]

FYI,

I just ran a fresh install with npvr 2.0.3 on winxp. I setup the hdpvr but forgot to set the channel changer. I went back in to edit it and point it to the haupblast.exe. I hit OK and exited. The change, however, doesn't seem to be saved. I've tried it a couple of times with no luck.

The workaround was to go back and install 1.5.36, setup the hdpvr and then upgrade to version 2.03.

Edit:

Oh, the changers not sick...just my spelling

[sub]

This is a known problem. I'm still thinking about how to handle it long term, but the attached patch should do the job for now.

[dark_half]

I tried the patch but still cannot save the channel changer settings.

[sub]

Try watching a channel then post the nrecord.log and I'll take a look.

[dark_half]

Well I guess am losing my mind because it is working now. I swear I tested it several times without success. Anyway thanks for help.

Jeff