Tuner disable not working?

[ttfitz]

Because of the problem in my other thread [URL="http://forums.nextpvr.com/showthread.php?53911-Looking-for-tuners-in-all-the-wrong-places]Looking-for-tuners-in-all-the-wrong-places[/URL], I had disabled the tuner in the devices setup screen, but when it came time tonight to record some shows, NPVR still used the tuner (apparently in an attempt to find a free tuner in order to do pre- or post-padding).

Shouldn't setting "enabled" to "No" mean it doesn't use that tuner?

I can post logs later if needed, right now it is in use and won't zip.

[sub]

If you do an 'empty epg' followed by an 'update epg', it'll hopefully correct this.

[ttfitz]

If you do an 'empty epg' followed by an 'update epg', it'll hopefully correct this.

Tried that, and it didn't help. Attached are the logs - "No More Back Pain" and "Workaholics" were finishing recording when "Futurama" was to start, and it went looking for a different tuner to use.

I should note, of the three tuners of the HDHR (capture sources 30-32, I assume), all three tuners are marked Present "Yes" and Enabled "No", with only tuner 2 having channels listed, the other two have 0 channels.

[ttfitz]

I should note, of the three tuners of the HDHR (capture sources 30-32, I assume), all three tuners are marked Present "Yes" and Enabled "No", with only tuner 2 having channels listed, the other two have 0 channels.

As a follow up, when I remove the channels from tuner 2, it no longer tries to use the tuner as it did before.