2016-01-14, 08:55 PM
I tried searching but did not run across this exact issue. Hopefully this is useful to anybody else with a similar issue.
NexpPVR has been working fine in my setup with a Hauppauge WinTV HVR-950Q. Last week I upgraded to a WINTV-dualHD USB tuner. Then the fun started ...
The new tuner worked great, except when my computer resumed from sleep/standby. I was getting a lot of recording failures. It seemed that the tuner and recording service was somehow not getting started in time and the recording aborted. Everthing else failed after that until a reboot.
I finally got into Windows 7 Control Panel> Device Manager> USB Root Hub (for the hub that was connected to my tuner)> USB Root Hub Properties> Power Management, and un-checked the box that says "Allow the computer to turn off this device to save power".
If it's not to soon to say so, it has been recording fine for the past few days ... as well as sleeping/resuming on schedule :-)
NexpPVR has been working fine in my setup with a Hauppauge WinTV HVR-950Q. Last week I upgraded to a WINTV-dualHD USB tuner. Then the fun started ...
The new tuner worked great, except when my computer resumed from sleep/standby. I was getting a lot of recording failures. It seemed that the tuner and recording service was somehow not getting started in time and the recording aborted. Everthing else failed after that until a reboot.
I finally got into Windows 7 Control Panel> Device Manager> USB Root Hub (for the hub that was connected to my tuner)> USB Root Hub Properties> Power Management, and un-checked the box that says "Allow the computer to turn off this device to save power".
If it's not to soon to say so, it has been recording fine for the past few days ... as well as sleeping/resuming on schedule :-)