(2021-03-03, 10:27 AM)lostboy Wrote: So have you tried your h/w tester on the lnb cable at end that connects to the telestar?
I think I did, I will do tonite and test again. Thanks for all the help.
Can someone please tell me, how I need to format a URL for a valid FTA Channel to the SAT-Ip Device, to open Stream in VLC?
2021-03-07, 08:32 PM (This post was last modified: 2021-03-07, 08:34 PM by Qvex23.)
Good and Bad News. I was on the wrong Satelite (Astra 4B instead Astra 1H). I changed to Astra 1H an could perfectly watch TV on my Satelite Finder. Even TVHeadend finds 1500 Channels, but NextPVR doesnt find any Channel
If you're willing to temporarily setup your router so I can access your port 554 on your SAT>IP device (172.27.0.11), and PM me the IP address:port you've forwarded, I'll try scanning it here, and see what it's unhappy about.
2021-03-07, 08:44 PM (This post was last modified: 2021-03-07, 08:47 PM by Qvex23.)
(2021-03-07, 08:39 PM)sub Wrote: If you're willing to temporarily setup your router so I can access your port 554 on your SAT>IP device (172.27.0.11), and PM me the IP address:port you've forwarded, I'll try scanning it here, and see what it's unhappy about.
Actually I'm not sure I'm going to be able to do it remotely the way I was trying. There is udp stuff that isn't going make it through the firewall.
Restart NextPVR, then on the Settings->About page, hold the Ctrl key. Click the 'enable verbose' button that appears, then try scanning again, and repost the logs.
2021-03-07, 09:13 PM (This post was last modified: 2021-03-07, 09:13 PM by Qvex23.)
(2021-03-07, 09:00 PM)sub Wrote: Actually I'm not sure I'm going to be able to do it remotely the way I was trying. There is udp stuff that isn't going make it through the firewall.
Restart NextPVR, then on the Settings->About page, hold the Ctrl key. Click the 'enable verbose' button that appears, then try scanning again, and repost the logs.
Ok. I enabled Verbose. The Portforwarding was for TCP and UDP. Maybe I can let you Tunnel into my network for debugging if you want