intermittent audio with hauppauge wintv 150

[samlimster]

Hi folks.

Just downloaded and installed GBPVR and it is fantastic. Much better than the wintv software that came with my hauppauge wintv pvr 150.

I am, however, having problems with audio. Sometimes when I change channels using the remote control, the moment the channel changes, audio is missing. If I switch to another channel the audio may come back and if I go back to the original channel, the audio is sometimes still missing or sometimes restored. There doesn't appear to be any pattern to determine if audio will be missing. I've watched a channel with audio for several minutes and it goes uninterrupted until I change the channel.

Has anyone else seen this problem? Anyone have any ideas?

I had the audio setup for my pvr150 set to all default values (sampling rate at 48khz, etc) and tried change the values, but that didn't appear to help.

Thanks in advance!

sam.

[samlimster]

Trying to characterize the problem further. When the audio is lost on several channel flips in a row, changing channel to channel 2 tends to always restore the audio. I can then flip to other channels and the audio will be present (until, of course it cuts out again)

[capone]

It's bad drivers. Update to the newsest 150 drivers. I know these fix it

http://www.shspvr.com/forum/viewtopic.php?t=7843

[samlimster]

I tried updating to the latest drivers as stated above. I also tried uninstalling and re-installing gbpvr. Nothing appears to be helping.

Are there any more ideas?