I'm new to GBPVR, previously I was with MediaPortal. I am getting sound, but no image when I try to use the 'Live TV' feature. My remote is able to change channel (I hear the output change). My machine is using a Hauppage PVR 150 MCE to capture, and an ATI Radeon 9000 to output.

I can play recorded AVI's just fine. I have configure the GBPVR source according to the walk through so I'm guessing that the problem is with the ATI. Any ideas?

I was just building some PC's for a client and recently started to use the ASUS M2NPV-VM board. It uses AMD AM2 cpu's but what really caught my attention is that besides being a nice small mATX board with passive chipset cooling and onboard Firewire, it also has on-board Nvidia 6150 video and comes with 5 video outputs on the board!! It has VGA, DVI , S-Video,Composite and has a component output as well (RBG). These boards are @ $110 CDN and I think I will pick one up and put a low cost Sempron chip in it for my next GBPVR upgrade.

FYI

can the mvp display gb-pvr in widescreen, if so, how?

I recently replaced my hard drive and installed GBPVR 99.12 fresh. Problem is I can't see the recorded shows in the "Recordings" screen of GBPVR but I can find them by going to Video Library. I can't seem to find a setting in Config to fix it. Any ideas?

Event Ghost is so much more powerful than HIP, it has native support for MCE Remote.

Event Ghost is so much more powerful than HIP, it has native support for MCE Remote. Guide is here.

Greetings sub

Could you possibly find a minute or two to look over my logs. I have the setting to "Error" and there are some in the logs that my being too new don't understand.

Hey guys, I'm a DirecTv subscriber so that entitles me to about 30 XM radio stations that are broadcast in the 800's channels on DirecTv. What I'd like to do is stream a given station so that I can listen to the audio only at work. Anyone have any ideas on how I might pull this off? The audio is being handle by one of my PVR150s via rca cables.

Greetings

I am trying to run something against a recording via PostProcessing and I see the usage is

PostProcessing [Filename] [Channel Number]

Question I have is how do I determine the path ?
or does the [Filename] contain the path as well as the filename ?

Could someone please tell me the name of the video issue I am experiencing so I can then research to solve the problem? Right now I'm unclear as to what I should search for so I am unable to find any solutions to this issue. I have recreated the pattern I am seeing at the top of the video for clarity.



Thanks