Channel Mapping Question

[motom]

Hi,

I am so close to getting this to work, but I'm still having problems getting the channels to show properly.

I think my channel numbering is the problem and I am unsure of what channel numbers go where. I used the autotune sw to get the channel frequencies and channel numbers but those don't match with the channel numbers in WinTV or the ones from XMLTV.

WinTV scans my channels fine but when I tried entering those numbers in the Capture Source -> Source Channels table it didn't help any.

I have tried using the FreqCopy (messed up my WinTV channels) and Freq2Reg (which I couldn't find the correct syntax to work) and nothing worked. I tried setting the Recording Source->Tuning to antenna and that got some of the channels to work it seems, but only about half.

If someone could help and explain what channels numbers go where, that would be great.

All help appreciated!
-Ola

[sub]

Run the tuning assistant to find what the channel numbers should be for each channel.